Our safety light curtains and other equipment are composed of a transmitter and a receiver. The height and width of the protected area are determined by the generated infrared rays. There are control and evaluation logic in the two devices. The M12 connector located at the bottom of the measuring light curtain achieve electrical connection. Its transmitter and receiver are optically synchronized, so they do not have to be directly connected to each other, the infrared beam is controlled and monitored by a microprocessor, and the operating status is displayed through LEDs. Two yellow LEDs enable easy alignment of the safety light curtain during installation. As soon as an object interferes with the beam emitted by the transmitter, the OSSD output is switched from high to low and the danger zone movement is switched off. Of course, it can be directly converted into some kind of signal, input into the computer and then calculated to achieve the result we want.

For example, the spray grating is when the object to be sprayed passes, the object will block the transmitter and receiver of the spray light curtain, which will give a signal, the final spray, smart, fast and safe, and the counting light curtain is our small zero When the parts pass through at a constant speed, the infrared rays of the measuring light curtain will be intercepted, so that the counting is accurate and fast.