How to install safety light curtain grating The bracket allows a rotation angle of ±30°. The following is the specific installation method of the measuring grating:

1. First determine the installation position of the measuring grating transmitter and receiver, ensure that they are in the same plane, and their midpoints can be completely aligned, and install the mounting bracket with shock-proof bolts and M4 screws (supplied with the sensor). In situations where the vibration is not strong, M4 or #8-32 bolts can be used to replace the shock-proof bolts. Although the internal circuits of the detection light curtain transmitter and receiver are resistant to strong vibrations, we recommend the use of anti-vibration bolts to eliminate possible damage to the sensor caused by strong vibrations.

Receiver and Receiver Wiring Diagram

Receiver output 1: It is an NPN transistor output with an open collector, the maximum breaking voltage is 30V dc, and the maximum breaking current is 150mA. With overload and short circuit protection. Receiver alarm output: It is an NPN transistor output with an open collector, the maximum breaking voltage is 30V dc, and the maximum breaking current is 150mA. With overload and short circuit protection.

2. How to install the detection light curtain? Install the detection light curtain transmitter and receiver on the bracket, install their lenses face-to-face, their outlet directions should be the same, measure the height of the two to determine whether they are aligned, make appropriate adjustments, So that the measuring grating transmitter and receiver are completely aligned, and finally tighten the screws.

3. Connect the safety light curtain cable to the transmitter and receiver, the excess cable can be cut off, the same cable used for the transmitter and receiver (2 cables are required for each system)

4..'Our safety light curtain launch